THE ENDURANCE WARM WATER BOILER
Manufactured by Teledyne-Laars,
the Endurance boiler uses technology that was originated in research done for
a NASA project. Its numerous safety features, high efficiency, plentiful
on-demand domestic hot water, quiet operation, and numerous other features
make the Endurance a sound choice as the heat source for our quality systems.
Installation Almost Anywhere.
An internal bypass, built-in pump, venting options, small footprint and
minimal clearances allow for fast, flexible installation and effortless
start-up.
Environmentally Friendly.
NOx
levels of less than 25 ppm and 85%AFUE
Domestic Hot Water Heating.
The EBP combines boiler operation with a steel storage tank to provide
abundant domestic water heating to the home -- 180 continuous gallons per hour
at 100 F rise, 5 intermittent gallons per minute.
Save Big on Fuel
Bills.
Innovative full
modulation. Endurance
automatically adjusts to the homes' varied heat demands. This saves
energy and adds comfort by maintaining an even temperature throughout the
home.
Comfort and Safety.
Endurance provides natural, even heat. There are no hot blasts of
air, cold spots or chilly corners. And the sealed combustion design
safeguards against the possibility of gas or fumes leaking into the house.
Endurance is a perfect fit for radiant floor applications.
Self-Monitoring.
With a sleek design encompassing leading
edge technology, Endurance has a built-in microprocessor that guarantees
overall performance by monitoring the boiler, tank and flow temperatures.
The microprocessor also features a diagnostic display to greatly simplify
servicing.
Available in Three Models and Two Sizes.
Setting a new industry standard,
Endurance is a gas-fired, fully modulating, sealed combustion boiler.
Endurance is offered in two sizes: the 110 modulates from 61,800 to 108,200
BTU/hr., and the 175 modulates from 102,900 to 175,300 BTU/hr.
Boiler Stats:
- Automatic burner
modulation from 57% to full fire
- Venting - Direct
vent (sealed combustion with ducted combustion air in concentric vent) or
Category III
- No standing pilot
light -- safe, installs anywhere
- Hot surface
ignition
- Built-in
diagnostics with memory and 3-character alpha-numeric temperature readout
and error codes
- High efficiency
-- saves fuel and money
- Electrical -
115V-60HZ-1 PH less than 15 amps with 24V transformer mounted and wired
Built-in circulating pump and by-pass loop
- Equipped with
anti-condensing controls
- Built-in freeze
protection
- Pump
exercizer to ensure pump remains free from
corrosion
- Built-in overheat
thermostat (safety limit)
- 20 year limited
warranty
- Design certified
and tested by International Approval Services (American & Canadian Gas
Associations)
- Material
specifications per ASME code, Section IV
- Maximum working
pressure - water 30 RS.I, ASME rated
- Hydrostatic test
pressure at factory - 60 RS.I. Natural or propane gas
- Minimum gas
supply pressure - 4" w.c.
Maximum gas supply pressure - 13" w.c.